Electrical Engineer

Job Description : ELECTRICAL ENGINEER NIGERIA PP AND PDH Bachelor of Engineering-Electrical, from a reputed institute Minimum Experience required 13 to 15 Years in Petrochemical / Fertilizer / Refinery sector Candidates should have worked in any mega project, from the Engineering phase to its Pre-Commissioning & Commissioning and in the Operation & Maintenance phase later Knowledge & Skills required Good knowledge of various engineering standards and codes Should have in-depth knowledge as well as hands-on experience in the following - HT & LT Transformers, Switchgears, Electrical Control Systems, Relays incl numerical relays and their programming Relays incl numerical relays and their programming, SF6 Breakers, VCBs and Vacuum contactors HT & LT Motors, VFDs, Motor Operated Valves, Battery Chargers, UPS, DG Sets, Electric heaters Grounding, Lightning protection systems, Heat tracing systems Cathodic Protection systems Hazardous Area Classification & Equipment selection Instrument Electrical Interfaces Electrical system preventive maintenance, fault detection procedures and repair processes, etc In-depth understanding of Engineering Documents like Equipment specifications, Data sheets, SLDs. Switchboard Load distribution, Cable routing plans, Wiring diagrams for Switchboards/ MCC / Panels, etc, Terminal connection drawings, Emergency Power supply, Load Shedding, etc Participation in HAZOP, Process Hazard Analysis, etc Good understanding of PSM and Workplace safety standards Hands-on experience in all modules of ERP / EAM and Turnaround Planning & Management Good knowledge of Quality / Safety / Environment Management systems Demonstrates good analytical and trouble shooting skills Good Vendor management & Contractor management skills Possesses good written and verbal communication skills Job Profile Candidate shall work in the ongoing greenfield Propane Dehydrogenation [PDH] & PP Project Shall be responsible for all the Electrical related aspects during the Engineering phase of the project Review all Engineering Documents like Engineering Documents like Equipment specifications, Data sheets, SLDs. Switchboard Load distribution, Cable routing plans, Wiring diagrams for Switchboards/ MCC / Panels, etc, Terminal connection drawings, Emergency Load distribution, etc Prepare Equipment Inspection checklists for various phases including Factory Inspection, Site installation, Equipment cabling & terminations, etc Coordinate and conduct pre-inspection meetings with various Vendors & OEMs Certify Factory Acceptance Tests (FAT) at vendor shop & Site Acceptance Tests (SAT) of various Equipment as conforming to their data sheets and the relevant project standards Coordination with Engineering Contractor/ Construction contractor / Vendors/ OEM for project queries and their resolution, for scheduling and for delivery of equipment Inspection of various construction activities performed by construction contractor like Cable laying, Cable tray installation, Junction box installation, Wiring and termination, as per the approved engineering documents. Co-ordination with construction contractor for Loop checks, Test Pack certification, as well as Pre-Commissioning and Commissioning activities Liaising with Instrumentation, Mechanical, Operations & Piping for Interface activities Co-ordination with construction contractor for Equipment Installation, Cabling and Terminations, JB installation, Loop checks, etc Supervise the Installation, Pre-Commissioning and Commissioning of Transformers, Breakers, Switchgears, Panels, DG sets and other electrical equipment Monitoring Progress of Job Planned vs. Actual at each phase of the project and flag critical hold points Participate in various Pre Start-up Safety Reviews and take actions for close out all audit points Post Pre-commissioning and Commissioning activities, Candidate shall migrate to Plant Operations Shall independently handle all the planning and execution of Preventive Maintenance as well as any Breakdown Maintenance, Spares and Inventory management, Budget Planning, etc Shall be responsible for Turnaround planning and its management Shall ensure that all safety standards and procedures are followed during job execution Preparation of Standard Maintenance Procedures and Checklists for all equipment / instruments Render training to local and expat staff, as required Develop a team to work independently

---